Interconnecting Cisco Network Devices 2

1. Small Network Implementation

• Review Lab: Review of a Small Network Environment

2. Medium-Sized Switched Network Construction

• Implementing VLANs and Trunks
• Improving Performance with Spanning Tree
• Routing Between VLANs
• Securing the Expanded Network
• Troubleshooting Switched Networks

3. Medium-Sized Routed Network Construction

• Reviewing Routing Operations
• Implementing VLSM

4. Single Area OSPF Implementation

• Implementing OSPF
• Troubleshooting OSPF

5. EIGRP Implementation

• Implementing EIGRP
• Troubleshooting EIGRP

6. Access Control Lists (ACLs)

• ACL Operation
• Configuring and Troubleshooting ACLs

7. Address Space Management

• Scaling the Network with NAT and PAT
• Transitioning to IPv6

8. LAN Extension into a WAN

• Establishing a Point-to-Point WAN Connection with PPP
• Establishing a WAN Connection with Frame Relay
• Troubleshooting Frame Relay WANs
• Introducing VPN Solutions
  

Labs
Lab 1: Implementing a Small Network (Review Lab)
Using the skills that you acquired or learned in the ICND1 course, configure your workgroup switch and router with a basic configuration based on the network information provided.

Lab 2: Configuring Expanded Switch Networks
Expand the switch configuration to meet specific VLAN and network requirements.

Lab 3: Troubleshooting Switched Networks
Utilize troubleshooting methods discussed to gather symptoms, isolate problems, and correct the problems commonly found in a switched network.

Lab 4: Implementing OSPF
Configure your workgroup routers to use the dynamic routing protocol OSPF.

Lab 5: Troubleshooting OSPF
Utilize troubleshooting methods discussed to gather symptoms, isolate problems, and correct the problems commonly found when running the OSPF routing protocol.

Lab 6: Implementing EIGRP
Configure you workgroup routers to migrate from OSPF to EIGRP.

Lab 7: Troubleshooting EIGRP
Utilize troubleshooting methods discussed to gather symptoms, isolate problems, and correct the problems commonly found when running the EIGRP routing protocol.

Lab 8: Implementing and Troubleshooting Access Control Lists (ACLs)
Create and troubleshoot IP ACLs.

Lab 9: Configuring NAT and Port Address Translation (PAT)
Configure your workgroup router to use PAT.

Lab 10: Implementing IPv6
Allocate and configure IPv6 addresses on your workgroup routers.

Lab 11: Establishing a Frame Relay WAN
Using the serial interface, create a Frame Relay connection to the Core.

Lab 12: Troubleshooting Frame Relay WANs
Utilize troubleshooting methods discussed to gather symptoms, isolate problems, and correct the problems commonly found in a Frame Relay network.

Lo studente deve aver frequentato

• ICND1 (Interconnecting Cisco Network Devices 1)

Questo corso è parte dei programmi per le seguenti certificazioni:

CCDP (Cisco Certified Design Professional)
CCNA (Cisco Certified Network Associate)
CCNP (Cisco Certified Network Professional)
CCDA (Cisco Certified Design Associate)
CCSP (Cisco Certified Security Professional)